Hello
I am doing a evaporative cooling project. I have two domain (see the figure). One is for air, another is for water. Problem is, when I try to give flux at the interface boundary, comsol is showing it is not applicable. How can I solve this? See the figure.![]()
![]()
![]()
![]()
![]()
![]()
![]()
I am doing a evaporative cooling project. I have two domain (see the figure). One is for air, another is for water. Problem is, when I try to give flux at the interface boundary, comsol is showing it is not applicable. How can I solve this? See the figure.